BorMann 035947, Manual, Page: 5 / 43

EN
WWW.BORMANNTOOLS.COM
5
Controls and Functions
ON/OFF Switch: The ON/OFF switch turns the power to the sprayer on and off (O=OFF, l=ON).
Suction tube: Fluid is drawn through the suction tube into the pump.
Fluid Section: A piston in the fluid section moves up and down to create the suction that draws fluid through the suction tube.
Spray Gun: The spray gun controls the delivery of the fluid being pumped. The gun model you have depends on your sprayer model.
Spray Hose: The spray hose connects the gun to the pump.
Return Tube: Fluid is sent back out through the return tube to the original container when PRIME/SPRAY knob is in PRIME position.
PRIME/SPRAY Knob: The PRIME/SPRAY knob directs fluid to the spray hose when set to SPRAY or the return tube when set to PRIME. The arrows on the
PRIME/SPRAY knob shows the rotation directions for PRIME and SPRAY. The PRIME/SPRAY knob is also used to relieve pressure built up in the spray hose (see
Pressure Relief Procedure,).
Pressure Control Dial: The pressure control dial regulates the amount of force the pump uses to push the fluid.
Oiler: The oiler is designed to provide lubrication to the fluid section of the pump.
Pusher stem: The pusher stem is designed to keep the inlet valve open and from sticking due to dried materials.
Assembly instructions
Do not plug in the sprayer until setup is complete.
Tools needed for assembly:
1. Two adjustable wrenches
2. 3/16” Allen wrench
3. Extension cord (refer to Important Electrical Information
4. Thread the high pressure hose to the spray hose port.
Tighten with a n adjustable wrench.
5. Thread the other end of the hose to the spray gun. Hold
the gun with one adjustable wrench, and tighten the hose nut
with the other.
The spray tip should not
be attached untill after the sprayer
and spray hose have been purged
and primed.
6. Thread the suction tube onto
the inlet valve and tighten firmly
by hand. Be sure that the threads
are straight so that the fitting
turns freely.
7. Press the return tube onto the return tube fitting. Squeeze clip
over the return tube fitting to secure the return tube.
8. Verify that the seal is present inside the suction tube. Thread the inlet filter into the end of the suction tube.