BorMann 030751, User Manual

Page: 7 / 16

EN
WWW.BORMANNTOOLS.COM
7
Notes: Except ''continuous mode'' operation the timer set will be cancelled whenever ''mode switch'' is pressed. Set the timer again after pressing ''mode
switch'', if necessary.
The timer stops when the water tank is full of water. After the tank is emptied, the timer will start.
Maintenance
Warning: To avoid of the risk of electric shock, never connect and disconnect the plug with your hand wet.
Cautions: Turn off the unit and disconnect the power plug before cleaning of other routine maintenance.
Do not remove the float lever from the water tank.
When the unit is not in use for a long time
1. Unplug the unit, bundle the power cord, and hang the bundled cord at the back of the unit as shown.
2. Empty the water out of water tank, wipe the tank with cloth and replace in position.
3. Clean the air clean filter.
4. For storing, stand the unit upright and avoid the exposure to the direct sunlight.
Request
To avoid malfunctions or abnormal sound, keep the unit upright.
Body of dehumidifier
Wipe the dehumidifier with a dry and soft cloth.
To remove heavy dirt, wipe it with a cloth wrung tightly (never use a wet cloth for cleaning the
controls).
To avoid deformation or cracking, do not use benzine, thinner or liquid cleaners.
Chemical cloth may cause the change in colour of the unit.
Water tank
Pull out the water tank and take it out.
Wash the inside of the tank with water.
The tank may be scratched, if you scrub it strongly with a brush.
Do not remove the float lever from the tank.
Wipe off the water on the outside of tank with a cloth and replace the tank as it was.
The water tank should be cleaned every few weeks to prevent growth of mould, mildew and bacteria.
Partially fill the tank with clean water and add a little mild detergent. Swish it around and then empty the tank and rinse.
To thoroughly clean and dry the tank you can remove the handle and lid to gain access to the inside of the tank.
Follow these instructions:
Handle
Move handle to this position Detach the handle Remove handle and water tank cover You can now access inside of water
tank
Note: After cleaning, drying and reassembling the water tank, it must be reinserted securely into dehumidifier in order to restart operation.
Back and side air intakes (maintenance every 2 weeks)
The dehumidifying capacity will be lowered when the air clean filter gets clogged.
Remove the back cover from the unit, then take out the air filter.
To dislodge the dust from these filters, use a vaccum cleaner or pat the lightly.
If the filters are fouled seriously, wash in water including neutral detergent, rinse well with water and leave until dry.
Pat the air clean filter and dislodge dust from it.