4
www.BormannTools.com
Attention! Through poor conditions of the electrical MAINS, shortly voltage drops can appear when starting the EQUIPMENT. This
can influence other equipment (eg. Blinking of a lamp). If the MAINS-IMPEDANCE Zmax<0.195OHM, such disturbances are not
expected. (In case of need, you may contact your local supply authority for further information).
APPLICATIONS
Crushing concrete, chipping, digging, and squaring. (Application Examples
）
Installation of piping and wiring, sanitary facility installation, machinery installation, water supply and drainage work, interior jobs,
harbor facilities and other civil engineering work.
Prior to operation
1.
Power source
Ensure that the power source to be utilized conforms to the power requirements specified on the product nameplate.
2.
Grounding
This tool should be grounded while in use to protect the operator from electric shock.
The tool is equipped with a three-conductor cord and grounding type receptacle, the green (or green and yellow) conductor in the
cord is the grounding wire. Never connect the green (or green and yellow) wire to a live or neutral terminal.
3.
Power switch (5)
Ensure that the power switch in the OFF position. If the plug is connected to a power receptacle while the power tool while start
operating immediately, inviting serious accident.
NOTICE: A.3-1 (8) picture On-Off switch, When the A.3-2(9) indicator light show the power tools connected to the power, can
start work.
4.
Extensional cord
When the work area is removed from the power source, use an extension cord of sufficient thickness and rated capacity.
The extension cord should be kept as short as practicable.
5.
Mounting a tool
Note: When handling bull point, cold chisel and other accessories, standard tools are recommended for better operation.
Handle Attachment (1)
For reasons of safe, only use the hammer drill with handle attachment.
You will be able to obtain a safe body position when work by rotating the handle attachment in an anticlockwise.
Safety Clutch (2)
The safety clutch is activated if the drill becomes jammed or caught. This prevents the machine from being wrenched from the
operator’s hand.
NOTICE: FUNCTION FOR THREE PICTURES
A.4-1: Only Hammer
A.4-2: Hammer &drill
A.4-3: Spindle Lock
Summary of Contents for 023180
Page 11: ...6 www BormannTools com ...
