BORK i 780, Operating Manual

Page: 9 / 15

14 15
CLEANING
• Disconnect the iron from mains before
cleaning.
• Wait until the iron plate cools completely.
• Use a damp sponge soaked in a mild soapy
solution in order to clean outer surfaces of the
iron.
• If the soleplate is contaminated heavily, then
it is necessary to apply special cleaning
agents.
Do not use abrasives, chemicals, cleaning
and aggressive powders or gels, since they can
damage the housing materia. Take the handle
or press one of the touch buttons in order
to turn the iron on once again.
Use only demineralized or distilled water
in order to prolong the life of your iron.
AUTOMATIC CLEANING FUNCTION
The automatic cleaning function removes
calcareous deposits accumulated in the tank.
Use this function once every 2-3 weeks or when
particles appear on the surface of a soleplate
of the iron.
• Fill the water tank with water not exceeding
the maximum level.
• Press and hold the temperature adjustment
sensor and steam supply level adjustment
sensor together for about 4 seconds.
The message CLEANING will appear on the
display and button holding shall be stopped.
2 sound signals will be issued. The automatic
cleaning function will be activated.
• Place the device over a large container in the
horizontal position. Steam and liquid will
be intensively taken out through the soleplate
of the iron.
The cleaning procedure lasts about 1 minute.
• Allow the device to cool in the vertical
position and then wipe the soleplate with
a cloth.
• Repeat the procedure, if necessary.
SYSTEM OF DELICATE FABRICS
PROTECTION
The iron kit includes the nozzle for delicate
fabrics, which is used for ironing of particularly
sensitive fabrics and prevents formation of gloss
on their surface.
• Place the nozzle on the soleplate of the iron
by inserting the front part of the soleplate
of the iron into the limiter firstly, as shown
in the photo. Then put the nozzle on
completely. A special magnetic fastener
located on the soleplate of the iron will fix
the nozzle fast and securely.
The nozzle can be used with any temperature
mode, but it is recommended to set
the temperature mode to WOOL and level
of steam supply to MIN in order to avoid
appearance of shiny spots on a particularly
sensitive fabric.
• Press the rubber holder located at the back
of the nozzle in order to remove the nozzle.
AUTOMATIC TURNING SHUTDOWN
The automatic shutdown system is activated
if the iron remains in one position for 30 seconds
in the horizontal or lateral state and 8 minutes –
in the vertical state.
A sound signal will be issued and heating
indicator will flash slowly prior to automatic
deactivation. The display and illumination
of the water tank will be turned off and heating
of the soleplate will be stopped.
Hold the handle or press one of the sensor
buttons in order to turn the iron on once again.
The device returns to temperature and steam
settings selected before shutdown after the
sound signal is issued. The device needs
time for heating to the previously selected
temperature after turning on.