BORK i 780, Operating Manual

Page: 10 / 15

16 17
• Please read this manual before application of
the device. A failure to comply with indicated
guidelines may lead to a personal injury and
damage to the property of a user.
• Before device operation make sure that
characteristics of mains correspond to those
indicated on the product label.
• Transportation of the device is allowed only
in the original packaging, as well as in a fixed
vertical position.
• Dispose the device in accordance and in
compliance with requirements of the national
legislation, implemented currently.
• In order to reduce the risk of an electric
shock, do not immerse the power cord, plug
or iron in whole in water.
• In order to avoid burns, do not touch the
soleplate of the iron, avoid direct steam
contact with unprotected parts of the body.
• Do not allow the power cord to come into
contact with the hot soleplate, since the cord
may be damaged.
• Install the device on a dry flat surface only.
• Always disconnect the iron from mains before
pouring water in or out from the tank.
• Pour water into the iron only using a special
water tank that comes in the kit, which shall
be used in an assembled position. Place the
iron in a horizontal position in order to fill or
top up water.
• Do not use the iron with an open hole, applied
to fill the water.
• Do not fill the water above the MAX mark,
since such measure may damage the device.
• Do not pour any anti-scale agents into the
water tank.
• Do not use perfumed water or special water
for ironing. These fluids can damage internal
parts of the steam generator system.
• Always unplug the iron from the electrical
outlet when leaving the device unattended
and after use.
• Always pour water out of the tank at the end
of ironing.
• Do not allow foreign bodies and liquid to
enter the housing of the device, since such
measure can lead to damage.
• Do not remove or damage an identification
plate with information about the device and
its serial number. It is necessary to identify the
device accurately in the event of a fault.
STORAGE
The device is recommended to be stored
in the assembled condition in a cool dry
place, isolated from places of storage of acids
and≈bases, at the temperature from 5 to 30°C
and relative humidity of 65%.
The iron kit includes a silicone stand for ease
of use. If necessary, take a break in operation
and place the iron horizontally on the stand.
TROUBLESHOOTING
Fault/problem Solution
Е2/Overheating It is necessary to cool the soleplate of the iron
E0/E1/E3
Fault of device operation Contact the authorized BORK service centre