![background image](http://html.mh-extra.com/html/boretti/sh-series/sh-series_operating-instructions-manual_2788446017.webp)
17
NL
FR
D
EN
Maintenance
Always disconnect the extractor before doing
any maintenance.
Cleaning
The extractor must be cleaned regularly, both
inside and outside. Use a cloth with a neutral
detergent for cleaning. Do not use abrasives!
Note: Not observing the cleaning standards for
the extractor and for replacing and cleaning
the filters may create a fire hazard. You are
therefore requested to follow the instructions.
Grease filter
The grease filter must be cleaned once a
month with mild detergents, by hand or in the
dishwasher at a low washing temperature and
with a short washing cycle.
Carbon filter (filter version only)
The carbon filter may not be washed or reused.
The carbon filter must be replaced at least
once every 4 months.
Lamp replacement
If the BORETTI LUMINA LED illumination is no
longer working, please call Boretti’s technical
service.
Caution
Never a use the extractor when the grease fil-
ters are not fitted correctly! The extracted air
may not be discharged into a duct that is also
used for extracting smoke from devices which
do not run on electricity.
Always ensure that the room is well ventilated
when the extractor and any other appliances
are used. Cooking on open flames under the
extraction hood is strictly forbidden. Open
flames will damage the filters, electronics, mo-
tor and illumination and can start a fire. When
frying, watch out constantly that hot fat does
not catch fire.
Strictly observe the technical and safety regu-
lations for the extraction of smoke as laid down
by the relevant local authorities.
time will set the timer at 20 minutes and but-
ton E will flash three times repeatedly.
To switch off the delay timer, press button E
once again.
Filter indication
Button F will flash to indicate when your
grease filters need cleaning (after 40
hours operation). After 120 hours the F
button will light up when the carbon
filters need to be replaced (after 120
hours operation) if you are operating in
recirculation mode.
You can easily reset the filter indication
by pressing button F.
Hint
Switching on the extractor creates a current
of air. However, it can take a moment before
this current takes effect, which may create the
impression that the extractor is not working
properly. It is therefore advisable to set the
extractor at low speed a few minutes before
you start cooking, so that the air current can
already be effective when you start cooking;
this will also allow you to keep using your ex-
tractor at the lowest speeds. In this way your
extractor makes the least noise, uses the least
energy and gives the best results.