EN
23
Operation
www.bora.com
6 Operation
X
X
Observe all safety and warning information during
operation (see the Safety section).
INFO
The cooktop may only be operated when
the stainless steel grease filter of the
cooktop extractor is installed (see operating
instructions for cooktop extractor).
INFO
Clean the cooking zone before using the
cooktop for the first time (see the Cleaning
section).
6.1 General operating instructions
The cooktop is controlled using the control knobs.
Each cooking zone has its own control knob. The front
cooking zone is controlled using the left-hand knob and
the back cooking zone with the right-hand knob.
There are 9 power levels, one power setting and various
functions available for each cooking zone.
t
P
9
8
7
6
5
4
3
2
1
v
0
Fig. 6.1
Knob ring assignment
Knob ring position
Function
0
Switching off
v
Heat retention level
1 - 9
Power levels
P
Power setting
t
Timer function
Tab. 6.1 Knob ring positions
6.2 Operating the cooktop
6.2.1 Switching on the cooking zone
Fig. 6.2
Switching on the cooking zone
X
X
Turn the knob ring from the 12 o-clock position to a
power level.
Adjusting the power level
X
X
Turn the knob ring to the desired power level.
INFO
The selected power level is shown in the
middle 7 segment display on the control knob.
6.2.2 Power setting
Switching on the power setting
INFO
Both cooking zones are equipped with a power-
enhancing power setting.
INFO
The power setting cannot be activated is the
bridging function is switched on.
If a cooking zone is operated at power setting
P
, the other
cooking zones can be operated at a maximum power level
of
5
.
If the power setting is increased from
5
, the power level is
switched down from
P
.
If the power level is set higher than
5
when power
setting
P
is activated for the other cooking zone, it is
automatically reduced to power level
5
after 3 seconds
(the control knob display flashes for 3 seconds).
If the power setting
P
is deactivated again within these
3 seconds, the second cooking zone can continue to be
operated at the higher power level.
X
X
Twist the knob ring to the 10 o’clock position.
Q
Q
The control knob display shows
P
and the power
setting is activated.
Q
Q
After 10 minutes, the cooking zone is automatically
switched back to power level
9
.
Switching the power setting off early
X
X
Turn the knob ring to the desired power level.
Q
Q
The power level set is active and is shown in the
control knob display.
