EN
21
Installation
www.bora.com
Setting the volume of the warning beep
Once you have confirmed menu option
C0
, you can set the
volume of the warning beep.
Setting
Warning beep volume
C 00
100% (max. volume)
C0 1
10% (min. volume)
C 02
20%
C 03
30%
C 04
40%
C 05
50%
C 06
60%
Factory setting
C 07
70%
C 08
80%
C 09
90%
Tab. 5.5 Warning beep volume
Select mode
When you have confirmed menu option
C 1
, you can select
the operating mode.
Setting
Mode
C 1 0
Normal operating mode
Factory setting
C 1 1
Demo mode
Tab. 5.6 Operating modes
INFO
All the control knob functions are available
in demo mode. The heating function for the
cooktop is deactivated. Demo mode is used,
for example, for exhibitions.
0° or 180° installation
In menu option
C2
, you can set whether the cooktop is
installed rotated around 180°.
Setting
Display
C 2 0
Installation 0°
Factory setting
C2 1
Installation 180°
Tab. 5.7 Installation direction
INFO
For installation rotated around 180°, the
C2 1
assign the correct cooking zones inside the
control knob display.
5.6.3 Changing the setting
X
X
Turn the knob ring clockwise to increase the value.
X
X
Turn the knob ring anticlockwise to decrease the value.
X
X
Press the touch surface on the control knob again
for 1 second to confirm the new setting. The value
is saved and a beep sounds. The previously selected
menu option is shown again on the control knob
display.
X
X
Secure the main switch/automatic circuit breaker
against being switched back on without permission.
X
X
Make sure the power to the appliance is disconnected.
X
X
Only connect the cooktop using a permanent
connection to a power supply cable.
1
L1
2
N
PE
220 - 240 V~
Fig. 5.20 Connection diagram 1-phase
X
X
Check that installation has been done correctly.
X
X
Switch on the main switch/automatic circuit breaker.
X
X
Put the cooktop into operation (see the Operation
section).
X
X
Check that all the functions are working correctly.
5.6 Configuration menu
Once installation is complete, you can adjust the basic
settings for the cooktop, these can then be changed at
any time.
5.6.1 Accessing the configuration menu
X
X
Twist the control knob to the 11 o’clock position.
t
appears in the control knob display.
X
X
Press the touch surface of the control knob for a
second. The display switches to
000
.
X
X
Press the touch surface again within 3 seconds and
hold it down for 5 seconds.
Q
Q
The control knob display shows
C
, a beep sounds and
the configuration menu is available.
5.6.2 Select menu option
X
X
Turn the knob ring to select the menu option you want.
The following menu options are available:
Menu options
C 0
Volume of warning beep
C 1
Select operating mode (normal mode or demo mode)
C 2
0° or 180° installation
Tab. 5.4 Menu options in the configuration menu
X
X
Touch the touch surface on the control knob again for
1 second to confirm the menu you want.
Q
Q
The sub-menu is accessed and the display switches to
a three-character combination (e.g.
C23
).
INFO
In the three-character combination shown, the
right-hand figure shows the value saved in the
system.
