14
Sweep Point Count
5
Trigger
Free Run
Sweep Dwell
100.00 mS
Start Frequency
80 MHz
Stop Frequency
100 MHz
Amplitude
00.00 dBm
RF Out
Off
Sweep Run
Off
3.5
Operating Modes
The SGX1000 can be setup in CW mode to generate a CW signal at a user-specified frequency and
amplitude or in Sweep mode to step up or down through a set number of frequencies at a specific
amplitude with a settable dwell time. The frequency at each step is determined by the start/stop
frequencies and the sweep point count.
3.5.1
CW Mode
The CW operation mode is used to view and adjust CW signal generation at a user defined frequency
and amplitude, select a reference source and frequency, and to turn ON/OFF the RF output. A blue LED
indicator is illuminated when the RF output is active.
Frequency
- The CW output frequency of the generator is adjustable from GHz down to mHz resolution.
Amplitude
- The power level of the RF output is adjustable down to 0.1 dBm resolution.
Reference Source
- The Reference source of the generator can be set to use an internal reference or for
a user provided external source.
Reference Frequency
- The reference frequency is selectable between 10 MHz and 100 MHz for an
external source and fixed at 100 MHz for an internal source
RF Out
- The RF Output state can be toggled ON or OFF. There is an LED indicating the state.
Figure 3-5 shows the CW display while generating a 100 MHz signal at 0 dBm using the internal
reference.
Figure 3-5. SGX1000 CW Operation Mode Generating a 100 MHz signal.
