4
Shredding Credit Card
Insert the card into the top center of the feed opening. You can only cut up one credit card at the time.
Overloading
If you insert too much paper over the maximum shred capacity of the shredder, the indication light will be red
flashing, and the cutting unit will stop rotating. In this event, set the switch to
“REV” to remove the paper. Reduce
the number of sheets and try again.
Overheating
If the shredder working continuously with exceeding the indicated maximum operating time of 20 minutes, there
is a possibility of the motor overheating. In this event, the indication light will be red, the cutting unit will stop. You
should therefore set the switch to the
“AUTO” position and let the device cool down fo
r about 45 minutes. The
device will be automatically disconnected from the power and will restart on its own once the motor has cooled
down sufficiently.
Cutter Oiling Instructions
To ensure proper operation and function, periodic oiling of the cutting unit is required. Failure to oil your cutting
unit could result in reduced sheet capacity performance, excess noise, paper jams and possibly machine failure.
Oil your cutters every 5
th
or 6
th
time you empty the basket if excess squeaking and rubbing noise is coming from
the machine or if the shredders sheet capacity has diminished. Squeeze the lubricant across the full width of the
cutters or shred one piece of lubricant sheet accordingly. Touch the
AUTO
switch and insert paper to activate the
cutting unit forward for 3 seconds, then touch
REV
for 3 seconds again. Alternate between
AUTO
and
REV
at
least three times or until all paper scraps are cleared out.
