switch, wait 15 seconds and press the reset button located on the
handle.
8. Do not operate the machine in the same spot for a long period of
time. Carpet damage will result quickly with a dry pad or bonnet.
9. To maneuver over thresholds and floor grates, stop the machine
and tilt it back on the transport wheels.
10. When done scrubbing perform machine maintenance procedures.
oPeratinG tHe SoLution tanK
1. Fill the solution tank with a recommended solution from Bonnet
Pro. Other solutions may void your pump warranty.
WarninG: fire or explosion Hazard.
never use flammable Liquids.
for SafetY: When using machine, follow mixing
and handling instructions on chemical containers.
2. Lower handle to working position. Adjust the solution control knob
to disperse solution to the pad/brush. Turn on the pump.
CLeaninG CarPetS
Before operating the machine on carpet, the carpet must be
presprayed with an approved cleaning solution. The solution will act
as a lubricant to allow the bonnet or pad to spin with less resistance.
for SafetY: to avoid a jolt when starting the machine on
carpet, use a recommended revive encap pad or bonnet and
wet the carpet under the bonnet or pad.
Do not use a brush that is intended for hard floors; personal injury
and carpet damage may result.
MaCHine MaintenanCe
WarninG: electrical hazard. unplug Power Cord Before
Servicing Machine
1. Remove and clean the pad driver/Multii Brush after each use.
2. Clean the machine base and chrome handle tube to allow proper
movement of the handle clamp after each use.
3. Rinse solution tank and solution supply hoses with clear water.
4. Inspect power cord for damage after each use. If worn or damaged,
replace immediately.
5. Wipe the power cord with damp cloth and neatly coil it around
cord handle after each use.
6. Periodically check that all bolts and nuts are tight.
7. Change oil after first 50 hours and every 500 hours thereafter.
See video at bonnetpro.com concerning oil changes and machine
maintenance.
tranSPortinG MaCHine
1. Unplug the power cord and remove the pad from the machine.
Neatly coil the cord around the cord hook and handle to prevent cord
damage.
2. Load the machine using a recommended loading ramp or carefully
lift the machine with adequate assistance.
for SafetY:
When transporting machine, get assistance when lifting
machine
3. Secure machine with tie--down straps when transporting by vehicle.
StorinG MaCHine
1. Do not remove brush/pad driver from machine while storing or
transporting. Damage to motor shaft may result and is not covered by
warranty. Neatly coil cord around cord handle.
2. Store machine in a dry area in the upright position.
WarninG:
Electrical Shock Hazard.
Do Not Use Outdoors. Do Not Expose to Rain. Store Indoors.
PLeaSe note: Do not fill solution tank on the
machine or when it is plugged in to prevent
damage to the motor or electrical shock.
Machine operation
6