WarninG
To prevent injury, always remove the electrical plug from the
electrical outlet before changing the Revive encapsulation pads or
bonnets and before leaving the machine.
PrePare tHe MaCHine for oPeration
To attach the drive block or brush or other attachment, be sure the
handle is “locked” in the upright position (See picture B on page 2).
Lay the floor machine on its back with the handle lying on the floor,
this exposes the driving plate on the underside of the floor machine.
Holding the drive block, brush or attachment in both hands and
straddling the motor with your back to the handlebox, bend over and
fit the three slots of the clutch plate (build into the back of the brush)
over the three lugs of the driving plate. Turn the drive block, brush
or attachment counter-clockwise as far as it will go until it is seated
in the ready-to-use position. (See picture #2) CAUTION: This is
the only proper way to install a drive block, brush or attachment.
NEVER put a drive block, brush or attachment on the machine by
placing it on the floor and moving the running machine over it, or by
placing the machine over the block or attachment and then starting
the motor. Return the floor machine to upright position and adjust
handle to operating position. Recommended handle position is close
to the waist near your hip bone with arms extended down. Lock the
cam release lever into position.
note:
The hardened steel cam release lever does not require
extreme tightening to effectively hold the handle in position.
Over-tightening will shorten the functional life of the lever. To
remove drive block, brush or attachment: Lay the floor
machine on it’s back again and disengage clutch plate slots from
driving plate lugs by turning clockwise.
HoW to oPerate tHe MaCHine
First install the pad driver and pad, brush or other attachments to be
used. Plug the machine in as directed and lower the handle to the
desired operating height and lock in place using the cam lever handle.
Push the lock out switch (see picture #3) and squeeze the
switch triggers beneath the handle grips. When the safety lock is
released place both hands on the handle grips for total control of
unit. This activates the motor and starts the block, brush or attachment
in operation. Each time you release the triggers the safety
switch will reset. You will need to follow the direction above to
restart the machine. CAUTION: When leaving the machine unattended,
disconnect the wall plug and return the handle to the
“locked” upright position to prevent accidental starting.
4
Pic. 3
safety Lock