n° 6BE648285NI-0606 –
Page 16
3.4.4 FITTING THE CONTROL PANEL
1) Start by outlining the location and drilling
the 3mm holes.
2) Open the facia and fit the back of the
control panel with 4 self tapping screws
3.4.5 FITTING THE COMPRESSOR COVER
(for GI models)
Fix the different pieces of the front cover on to the top of the side panels (where the
factory has drilled holes) using the n°8-19 self tapping screws supplied.
Across the width each join in the facia has an angled reinforcement.
Depending on the model (eg roll through) the corner angles are replaced by full panels.
4 self tapping screws
control panel
Facia
Model shown: 2x1C GI cabinet with 2 doors to the front control panel to the right
Facia for control panel
675243 (Single)
675244 (Right)
675245 (Left)
675246 (Central)
Facia without control panel
675247 (Single)
675248 (Right)
675249 (Left)
675250 (Central)
Sides
675242
Angle
675241
Sides
675242
Angle
675241
Angled stiffener
675240
M5 nut
M5 pan head
Self tapper CB n°8-19