Installation manual Bondtech Raise3D V2.0
3
Mechanical Installation
What you need
To install the upgrade, you are going to need:
-Hex wrench with sizes 2mm, 2,5mm and 3mm
-A sharp tool, for example a small knife
-A pliers
-Cable tie
Raise3D DualDirect and Raise3D SingleDirect
This guide shows the uninstallation of the original extruder (page 3-6)
And the installation on the DualDirect extruder (page 7-13) and SingleDirect extruder
(page 14-18).
•
Start by unloading the filament
from your printer.
After the filament is removed,
power off the printer.
● Start with uninstallation of the
original extruder. Note that the
two connectors are yellow and
white in this case, but the colors
may vary.
