Installation manual Bondtech Raise3D V2.0
11
•
Arrange the cables nicely
and use cable tie to secure
them on the top. Cut of the
end.
You are done with the
installation!
BLACK MOTOR
•
If you have the black
motors you will have to
change position of the two
outermost wires in the
“R”
connector to change the
rotation direction. Note
that it’s
only
the rear motor
connector.
•
To reverse two cables, you
can use a sharp tool to lift
the little plastic tab on the
connector and gently pull
the crimping contact out of
the housing with your
fingers.
•
Like this!
