8
CAUTION
If the burner does not ignite with the burner control valve open, gas will continue to flow
out of the burner and could accidentally ignite causing injury or property damage.
USING A LONG MATCH OR LIGHTER
1. Connect propane (LP) cylinder (See above pages).
2. Before lighting, move the lava rocks with a small shovel to allow access to the pilot located
inside the screen.
WARNING:
Lava rocks can become very hot. DO NOT touch unless they are completely cooled.
3. Locate the burner control knob and make sure it is in the "OFF" position.
4. Wearing heat resistant gloves position a lit long match or lit long neck lighter close to the pilot.
DO NOT lean over the burner while lighting.
5. Push and turn burner control knob to the "PILOT" position. The pilot
should light immediately.
6. If the pilot does not light immediately, turn the burner control knob to "OFF", wait
5 minutes for gas to clear and repeat the lighting procedure. If pilot still will not
light, refer to the Troubleshooting Section.
7. Flame height can be changed by adjusting the burner control knob between the "LOW" and
"HIGH" positions.
8. Always check burner flames periodically to ensure proper operation. Flames should be mostly
yellow with some blue for best performance.
TO EXTINGUISH
1. Push and turn burner control knob clockwise to the "PILOT" position. (Normally,burner
will make a slight popping sound when extinguished). Main burner will extinguish but Pilot
flame will remain ON.
2. To extinguish Pilot flame, depress Control Knob and continue to turn it clockwise to OFF.
3. Close the LP tank valve.
4. Disconnect the regulator from the LP tank to close the gas supply when not in use.
5. Make sure that the unit is completely cooled before touching any of the components or putting
on the cover.
ROUTINE CARE
• Keep your appliance free and clear from combustible materials.
• Visually inspect burner for obstructions, keep tank enclosure free and clear from debris.
• After the burner and lava rocks are completely cooled down, use a soft brush to get rid of the
mild stains, loose dirt and soil. Wipe with a soft cloth.
STUBBORN STAINS
• Stubborn stains, discoloration and possibly rust pitting can occur from exposure to harsh outdoor
conditions.
• Be careful not let any powder or solvent come in contact with painted or plastic components
as damage may occur.
MAINTENANCE
• Store the appliance in a cool dry place away from direct sunlight.
• Make sure both the gas and the appliance are turned off before changing battery. Please refer to
• Protect your appliance with the cover when not in use.
• The propane cylinder must be disconnected and stored outdoors before the appliance can be stored
indoors.
the process of inserting battery.
USING A LONG MATCH OR LIGHTER
