clockwise to off “ ”. Wait 5 minutes,
Turn ignition control knob to the off “ ” position. Connect propane gas tank to regulator and
Push the ignition control knob in and turn counterclockwise to the “ ” position; this will
To adjust the flame, turn the ignition control knob either clockwise or counterclockwise
If ignition does NOT immediately take place in seconds, push and turn the ignition control knob
LEAK TEST
1 Perform a leak test in a well ventilated area outside.
2 Make
sure
any
open
flames
or
cigarettes
are
extinguished.
3 Remove
the
battery.
4 Ensure the burner control knob is in the "OFF" position.
5 In a bowl, create a soap solution using 1 part water and 1 part liquid detergent.
6 Apply the soapy water solution to all connections.
7 Open LP tank valve.
8 A gas leak will be detected by expanding bubbles originating from the point of the leak.
9 If a leak is found at any connection point or if you smell gas, close the tank valve, disconnect the tank and do not use the
appliance until repairs can be made.
TO LIGHT
TIPS:
Before Beginning
●
Read and understand the instructions thoroughly.
●
Check and make sure that all parts are present.
●
For future reference, save this instruction sheet.
CAUTION
If the burner does not ignite with the burner control valve open, gas will continue to flow out of the burner and could
accidentally ignite causing injury or property damage.
USING A LONG MATCH OR LIGHTER
1 Connect
propane
(LP)
cylinder
(see
above
pages).
2 Before lighting, move the lava rocks with a small shovel to allow access to the burner.
WARNING: Lava rocks can become very hot. DO NOT touch unless they are completely cooled.
3 Locate the burner control knob and make sure it is in the "OFF" position.
9
1.
open the cylinder valve.
2.
ignite the fuel.
3.
then repeat the lighting procedure as above.
4.
raise the fame. Observe fame height when lit; fame should be a yellow/blue color between 2 inch to 10 inches high.
depending on whether you want to lower or
Always check burner flames periodically to ensure proper operation. Flames should be mostly yellow with some blue for
5.
bestperformance. (See diagram)
