Manual
BONA DCS25 Vacuum Cleaner
17
BONA AB
Assembling
•
Check that the packing is intact and has no sign of damage from handling and transport.
•
Unpack BONA DCS25 and check that all the ordered parts are there.
•
Make sure that the collection container is empty, and that the pre-filter / membrane filter is correctly fitted
into the motor top. Check that the filters of the machine are intact and undamaged (see the chapter:
“Change of Filter”)
•
Check that a collection bag is mounted in the container.
•
Before the plug is connected to the electrical main supply you must make sure that the plug and the cord
are undamaged. If the cord or the plug is damaged, a professional must replace the parts. Only an
original cord may be mounted.
•
Connect the machine to 230 V power supply with a reliable earth connection.
•
Remember to place the label onto the H-label, if the language of the user is not German.
•
BONA DCS25 is now ready for use. The collection is described in details in the following chapter.
Starting the BONA DCS25 and Collecting Dry Dust
When the machine has been correctly assembled and connected, it can be switched on and off at the red
start/stop switch of the motor top. The machine has been equipped with an acoustic and a visual alarm indicating
when the air flow is too low for collection.
This alarm has to be checked before use: Block the intake at the end of the hose, and the machine will start
beeping, and the LED will flash. Unblock, and the alarm will stop.
Electrical Outlet with Automatic Start/Stop
BONA DCS25 is equipped with an automatic start/stop and electrical outlet.
If you connect electrical hand tools directly to the power outlet of the motor
top, the BONA DCS25 will automatically be switched on and off when the
hand tools are switched on and off.
The automatic start/stop is programmed with a post-suction cycle.
Therefore, the suction will continue for some seconds after the tool has
been switched off.
The electrical tool is connected to the electrical outlet at the back of the
motor top.
BONA DCS25 can be used with tools with a power consumption of 2000 W
(Country code EU). 1450 W corresponds to a current consumption of
approx. 6,3A.
Information can be found on the data plate of the machine
