6 Operating
bon CP-50
GA bon CP-50 Rev 1.0 E 271205
15/21
6.6 Using several projectors in a room
You can use up to 5 separate projectors in a room, provided each projector is coded with the
appropriate remote control unit.
Coding the projector:
1. Switch the projector off at the mains.
2. Open the battery compartment in the remote control unit.
The following code can be set on the dip switch inside the remote control unit:
Select the required coding.
3. Close the battery compartment.
4. Point the remote control unit towards the projector, hold down program key [IN] while
switching on the projector at the mains.
5. Release program key [IN] once the projector has confirmed the code following
several short and one long signal tones.
If the projector does not signal that it has received the code, switch it off and repeat
step 4.
on
1 2 3 4
on
1 2 3 4
on
1 2 3 4
on
1 2 3 4
on
1 2 3 4
(Basic setting)
Switch 1 „on“
Switch 2 „on“
Switch 3 „on“
Switch 4 „on“
