50
ON POSITION “WITHOUT LIGHT”
7) Engine Stop Switch
Located on left side of handlebar. The
engine will turn over but will not start
if the engine stop switch is turned to
OFF position.
This switch can be used to stop engine
and as an emergency control.
NOTE:
While engine can be stopped
by turning ignition key OFF, we recom-
mend the engine be stopped by the
engine stop switch.
1. Engine stop switch
8) Start Button
Located on left side of handlebar.
To start engine, place the engine stop
switch to RUN.
Press and hold the start button. Release
immediately after engine is started.
1. Start button
To stop engine, fully release throttle le-
ver then use the engine stop switch.
9) Indicator Lights Cluster
NOTE:
When first turning switch to
ON (either position), the oil pressure
indicator light will turn on for a brief
moment. This validates its operation.
Thereafter, only the lights that are ac-
tivated will remain on (Reverse, Neu-
tral and high intensity lights).
Located on right side of cluster. They
light up to monitor different functions.
1. Engine temperature
2. High intensity
3. Oil pressure
4. Reverse
5. Neutral
Engine Temperature
When indicator light is ON, it indicates
the engine is overheating.
If engine overheats, refer to
Engine
Overheat
in SPECIAL PROCEDURES.
V01G1AY
1
V01G19Z
1
V01G190
V00I01Y
1
2
3
4
5
vmo2002_004a.book Page 50 Friday, August 3, 2001 10:27 AM
Summary of Contents for Quest 500 2002
Page 1: ......
Page 46: ...44 Label 8 Label 9 Label 10 Label 11 Label 12 V04M07Y V01M09Z V01M0BZ V04M08Y V04M0AL...
Page 100: ......