V02C10Y
1
1. Cooling plug
Drain the system completely and rein-
stall the drain plug.
Remove the temperature sensor on
the top of thermostat housing.
Fill radiator until coolant comes out by
the temperature sensor hole.
Install the temperature sensor and
continue the cooling system filling by
the radiator.
Complete the radiator filling.
Check the level in the coolant reservoir
and refill if necessary.
Run engine at idle with the radiator
cap off. Slowly add additional coolant
if necessary.
At this point, wait until engine reaches
normal operating temperature.
De-
press the throttle lever two or three
times; then add coolant if required.
Install radiator cap. Inspect all connec-
tions for leaks and check coolant level
in the reservoir.
Valves Adjustment
See an authorized Bombardier ATV
dealer for valves adjustment.
Insufficient clearance will cause loss
of power and possibly damage the
valves.
Excessive
clearance
will
cause noise.
Spark Arrester
The
muffler must be
periodically
purged of accumulated carbon. See
the MAINTENANCE CHART.
Removal
WARNING
Never run engine in an enclosed
area. Never perform this opera-
tion immediately after the engine
has been run because exhaust sys-
tem is very hot. Make sure that
there are no combustible materi-
als in the area. Wear eye protec-
tion and gloves. Never stand be-
hind the vehicle while purging ex-
haust system. Respect all applica-
ble laws and regulations.
Remove:
– the screws retaining the spark ar-
rester to the muffler
V02C06Y
1
2
1
1. Screws
2. Spark arrester
– spark arrester and sealant joint
_____________________
89
Summary of Contents for DS650 X 2005
