6
Delivery scope
Delivery scope
Delivery scope
Delivery scope
Drainpipe
Installation
Installation
Installation
Installation
WARNING:
WARNING:
WARNING:
WARNING:
The appliance must not be connected to the mains
during installing. Otherwise there is da
da
da
dannnnger to life
ger to life
ger to life
ger to life or
electric shock hazard
electric shock hazard
electric shock hazard
electric shock hazard!
Appliance location
Appliance location
Appliance location
Appliance location
•
The site should be located near a properly
grounded power socket.
•
Place the appliance so that all controls are easily
to reach and the appliance door can open without
being impeded.
•
Good ventilation around the appliance is required,
in order to dissipate the heat properly. Sufficient
clearance must be created for this purpose.
•
Make sure that the floor, on which the appliance is
installed, is even, heat-resistant and clean.
•
Take care of a solid and horizontal position of the
appliance. If the appliance is not horizontally lev-
eled, adjust the feet accordingly.
•
Avoid the installation:
Avoid the installation:
Avoid the installation:
Avoid the installation:
-
near heaters, next to a stove, direct sunlight or
any other heat sources;
-
at locations with high humidity (e.g. outdoors),
as metal parts would be susceptible to corro-
sion under such circumstances;
-
in rooms where the temperature drops below
5°C or above 35°C. Do not expose the appli-
ance any weather.
-
near volatile or flammable materials (e.g. gas,
fuel, alcohol, paint, etc.).
Adjusting the feet
Adjusting the feet
Adjusting the feet
Adjusting the feet
CAUTION:
CAUTION:
CAUTION:
CAUTION:
The feet must never be removed. Do not restrict the
floor clearance through carpets, strips of wood or
similar. Danger of heat accumulation!
Danger of heat accumulation!
Danger of heat accumulation!
Danger of heat accumulation!
•
Turn the feet to the right to let down the appli-
ance; turn to the left to lift it up. The feet must
have solid ground contact.
•
Check with a spirit level if the appliance is leveled
horizontally. If the appliance is not in balance, the
feet must be adjusted again.
Water discharge
Water discharge
Water discharge
Water discharge
It’s not necessary to discharge the condensed water
to the tank, it can be drained out directly.
Pull out already fitted
pipe..
.. and install the drain-
pipe which is scope of
delivery.
Electrical connection
Electrical connection
Electrical connection
Electrical connection
WAR
WAR
WAR
WARNING
NING
NING
NING::::
•
The installation to the mains supply must conform
to the local standards and regulations.
•
Improper connection may cause to an electric
electric
electric
electric
shock
shock
shock
shock!
•
Do not use multiple sockets or extension cords.
•
It is not allowed to modify the plug provided with
the appliance. If the plug does not fit properly to
the outlet, let install a proper outlet by an author-
ized specialist.
•
The accessibility of the power plug must always
be ensured in order to disconnect the appliance
from the power supply in case of an emergency.