6
03/2012
IMPORTANT
•
Do not expose the device to direct sunlight.
•
Do not place near heaters, next to a stove or any other heat sources.
•
Do not use the device outdoors.
•
Only install at a location with an ambient temperature suitable for the climate class of the device.
For information on the climate class, please refer to chapter “Specifications“ or to the rating label
located in the interior or on the rear side of the device.
•
Avoid installation at locations with high humidity (e.g. outdoors, bathroom), as metal parts would be
susceptible to corrosion under such circumstances.
•
Do not place the device near volatile or combustible materials (e.g. gas, fuel, alcohol, paint, etc.)
and in rooms which may have poor air circulation (e.g. garages).
•
Only place on a steady and safe surface.
•
If the device is not horizontally leveled, adjust the feet accordingly.
•
Electrical connection
The kind of current (AC) and the voltage must be conform with the data of the rating label, located
inside or outside on the back of the unit. In case of heavy voltage fluctuations, it is recommended to
use an automatic alternating current regulator.
The plug, together with the grounding conductor, must fit into the wall socket. The mains plug must be
freely accessible.
Mains cable
•
Do not extend or roll up the cable during operation.
•
Also, the cable must not be near the compressor on the rear side, since latter one gets hot during
operation. In case of any contact, the isolation would be damaged resulting in electric leakage.
•
The use of extension cables is not recommended.
•
Do not connect the device to the mains with wet hands.
•
Install the device for the wall socket to be freely accessible.
Leveling
The appliance should be level in order to eliminate vibration. To make the appliance level, it
should be upright and both adjusters should be in stable contact with the floor. You can also
adjust the level by unscrewing the appropriate level adjustment in the front (use your fingers or a
suitable spanner).
R
EVERSE
T
HE
D
OOR
O
PENING
If required, the door opening can be moved from the right (supplied condition) to the left side.
WARNING
When replacing the door stop, the device must be disconnected from the power supply. Always unplug
the device first.
Socket driver (8 mm), (10 mm)
Cross-shaped screwdriver
Putty knife or thin-blade screwdriver
1) Remove the three screws at the rear and the two
screws at the top of the Larder Freezer and remove
the lid.
5) Lay the Upright Freezer backward. Remove
the bottom hinge bracket using an 8 mm socket or
spanner.