BOMANN TSG 7402.1, Instruction Manual

Page: 74 / 124

74
remaining time and any error codes are dis-
played.
Control lamp: lights up, when dishwasher
salt needs refilling.
Control lamp: lights up, when the water
supply is closed, or the water tank is not filled.
Starting a program

The water supply must be opened to maximum
pressure OR the water tank must be filled.

Load the dishwasher baskets.

Fill in the detergent.

Turn on the appliance.

Set the required program options.

Start the operation.
Interior light
The interior light switches on automatically:
-
by opening the unit door in power-on or
standby mode,
-
by pressing a button during the rinse cycle
After about 5 minutes with the door open or after
the last button press, the interior light switches off.
Changing the program
CAUTION:
A program change should be done only a short
time after starting the program. Otherwise, maybe
detergent has been dissolved and rinse water
drained off.

First press the Start/Pause button to stop the
current rinse program.

Press the Program selection button for about
3 seconds.

Select a new program and start the new opera-
tion.
Forgot to add a dish?
WARNING:
Open the door very carefully during operation,
there is a risk of water squirting out.
Dishware can be added any time before detergent
has been dissolved or rinse water drained off.

Press the Start/Pause button to stop the opera-
tion. Once the spray arms have stopped, you
can fully open the appliance door.

Add forgotten dishware.

Press the Start/Pause button, the operation will
continue after approx. 10 seconds.
At the end of program
CAUTION:
Allow the appliance to cool down a bit after the
program has ended before you open it. This avoids
that steam escapes that causing long-term dam-
ages to your furniture.
At the end of the rinse cycle will sound a series of
signals; then the unit goes into standby mode.
If no operation takes place within 15 minutes, the
device switches off automatically - energy-saving!
Turn off

Turn off the appliance.

Close the water supply, if necessary!

Remove the dishes after cooling (see "Unload-
ing the dishwasher").

Leave the appliance door slightly open until the
next rinse cycle to avoid odors.

If the appliance is not in use for an extended
period, disconnect it from the power supply!