12
Control panel
Control panel
Control panel
Control panel
1.
Power button to switch on or off the power supply.
2.
Program selection button to select one of six rinse programs. By repeatedly pressing this button, you can
select the rinse program.
3.
The corresponding program control lamp indicates the selection of the rinse program.
4.
By repeatedly pressing this button, you can select a start delay time of 2, 4, 6 or 8 hours.
1 x press = 2h
2 x press = 4h
3 x press = 6h
4 x press = 8h
5 x press = delete
Choose the wanted program and press the start/pause button. The operation will start automatically after
the selected lead time has elapsed.
5.
Start/pause button to start or pause the selected or running rinse program.
program control lamp is flashing: operation
program control lamp is lighting: pause/standby
6.
Rinse aid warning lamp, lights up when the rinse aid dispenser needs to be refilled.
7.
The control lamp indicates the activated water supply.
8.
The corresponding control lamp indicates the selection of the start delay.
NOTE: When setting 6h, the lamps 2h and 4h lights at the same time.
Starting a
Starting a
Starting a
Starting a rinse
rinse
rinse
rinse program
program
program
program
•
The water supply must be opened up to the maximum pressure.
•
Load the dishwasher basket.
•
Fill in the detergent.
•
Close the appliance door and press the power button to switch on the appliance.
•
Select the desired rinse cycle.
•
Set the available options, if required.
•
Press the start/pause button and the dishwasher starts.
Program change
Program change
Program change
Program change
CAUTION:
CAUTION:
CAUTION:
CAUTION:
A program change should be done only a short time after starting the program. Otherwise, maybe detergent
has been released and already drained rinse water.
•
To do a program change, press the start/pause button. Then press the program selection button for sever-
al seconds. The appliance is in standby mode.
•
Select the desired program and press the start/pause button to start the new operation.
