PLANNING
GUIDE
www.Dacor.com Phone: (800) 793-0093
Specifications subject to change without notice.
Install all appliances according to accompanying installation instructions.
10.3
EDWH24S, IDWH24
24” Wide Built-In Dishwasher
A
B
Front
Drain hose
C
D Handle depth
2” (50.0 cm)
5 1/4” (13.5 cm) to
7 1/4” (18.5 cm)
Depth with door closed
Depth dimensions allow
for hose on back of unit
49 3/4” (126.4 cm)
Depth with door open
Side
3 1/4" (8.3 cm)
2 3/4" (7.0 cm)
54" (137 cm) long
Drain hose
44" (112 cm) long
Power cord
Back
60" (152 cm)
Water supply line
long
Do not modify
loop in hose
Product Dimensions
Model EDWH24S
Model IDWH24
Front Panel Type
Stainless steel
Integrated
front panel
2
(A) Width
24” (61.0 cm)
23 5/8” (60.0 cm)
(B) Height
34 3/8” (87.4 cm) to
36 1/2” (92.7 cm)
34 1/8” (86.7 cm) to
36 1/8” (91.8 cm)
3
(C) Depth
24” (61.0 cm)
22 7/8” (58.1 cm)
4
(D) Handle Depth
1
Epicure
®
: 2 1/2” (6.4 cm)
Millennia
®
: 2” (5.1 cm)
NA
1
Epicure handle kit PN: ADWE24H
Millennia handle kit PN: ADWM24H
2
Model IDWH24 requires installation of customer provided, custom overlay
door panel. It blends the exterior of the dishwasher into the overall kitchen
décor. Customer must also supply custom or standard appliance handle for
the front of the panel. See page 2/3 for more information.
3
Height with required trim kit installed.
4
Without custom front panel installed.
Product tolerances: ±1/16” (±1.6 mm)
otherwise stated
Document # PG10-005
Revised 07/16/10 Page 1/3
WarnIng
Observe all governing codes and ordinances during planning
•
and installation. Contact your local building department for
further information.
This appliance must be installed in accordance with the
•
accompanying installation instructions.
UtILIty CoNNECtIoN DImENSIoNS
approximate
Shipping Weight
108 lbs. (49 kg.).
Electrical Specifications
Dedicated Circuit required
Total
Connected Load
Grounded, 3-prong, electrical outlet
supplied by120 Vac,
60 Hz, 15 Amp. (circuit breaker)
11 Amp. @ 120 Vac, 60 Hz.
The above specifications are for reference only. For exact
■
specifications see the product data label, located inside the right door
jamb.
Do not use an extension cord.
■
Water Supply Specifications
Water Pressure:
■
4.2 to 125 p.s.i. (30-862 kPa) with minimum water
flow of 3 gallons (12 liters) per minute.
Water Supply Temperature:
■
Cold or hot water supply (maximum
140°F, 60°C) may be used. If a cold water supply is used, the washing
times will be longer but performance will not be affected.
Water Supply Valve requirement:
■
3/8” water supply valve for
connection to dishwasher’s water supply line is required in a location
where it is easily accessible after the dishwasher is installed. The
dishwasher water supply line is equipped with a 3/8” (10 mm) NPT
female compression fitting on the end.
