6
04/2010
INSTALLATION
Location
Sufficient ventilation around the device is necessary in order for the heat to dissipate properly and to
guarantee efficient cooling operation at low power consumption. For this purpose, leave sufficient
space around the device.
•
Minimum clearance of 5 cm between rear side and wall,
•
at least 20 cm on both sides and on the top of the device.
•
Leave proper space in front of the device in order to open both doors at an angle of 120°.
IMPORTANT
•
Do not expose the device to direct sunlight.
•
Do not place near heaters, next to a stove or any other heat sources.
•
Do not use the device outdoors.
•
Only install at a location with an ambient temperature suitable for the climate class of the device.
For information on the climate class, please refer to chapter “Specifications“ or to the rating label
located in the interior or on the rear side of the device.
•
Avoid installation at locations with high humidity (e.g. outdoors, bathroom), as metal parts would be
susceptible to corrosion under such circumstances.
•
Do not place the device near volatile or combustible materials (e.g. gas, fuel, alcohol, paint, etc.)
and in rooms which may have poor air circulation (e.g. garages).
•
Only place on a steady and safe surface.
•
This appliance is equipped with non-slip rubber feet. As furniture surfaces are made of a variety of
materials and are treated with many different types of cleaning agents, it cannot be completely ru-
led out that some of these substances may contain ingredients which could corrode the rubber
rests and soften them. If possible place an antislip material under the feet of the device.
•
If the device is not horizontally leveled, adjust the feet accordingly.
Power supply
The kind of current (AC) and the voltage must be conform with the data of the rating label, located
inside or outside on the back of the unit. In case of heavy voltage fluctuations, it is recommended to
use an automatic alternating current regulator.
The plug, together with the grounding conductor, must fit into the wall socket. The mains plug must be
freely accessible.
STARTUP/ OPERATION
Prior to first use
•
Clean the interior of the device including all accessory parts located inside.
Connect the device to the mains supply
IMPORTANT
The device must be earthed properly. For this purpose the plug of the mains cable has
been fitted with the intended lead.
IMPORTANT
Contact an electrician if the plug does not fit in the wall socket.
IMPORTANT
In case you disconnect the device or in case of power failure: Wait for 5 minutes before
restarting the device.