BOMANN GSP 857 IX, Instruction Manual, Page: 6 / 20

6
•
Take care of a solid and horizontal position of the
appliance. If the appliance is not horizontally lev-
eled, adjust the feet accordingly.
•
Power cord and water hoses may not kinked or
squashed.
•
Avoid the installation: Avoid the installation: Avoid the installation: Avoid the installation:
-
near heaters, next to a stove, direct sunlight
or any other heat sources;
-
at locations with high humidity (e.g. out-
doors), as metal parts would be susceptible
to corrosion under such circumstances;
-
in rooms where the temperature could drop
below freezing. Do not expose the appliance
any weather.
-
near volatile or flammable materials (e.g.
gas, fuel, alcohol, paint, etc.).
Installation steps Installation steps Installation steps Installation steps
Attach the Attach the Attach the Attach the condensation strip condensation strip condensation strip condensation strip
Attach the strip under the
wooden worktop to prevent
it from damages of ascend-
ing water vapor.
•
First clean and dry the concerned area of the
worktop thoroughly.
•
Remove the protective foil from the condensation
strip and stick it flush with the worktop edge.
Cabinet opening Cabinet opening Cabinet opening Cabinet opening
Prepare the cabinet opening
according the drawing.
Unit mm
If the appliance is installed at the corner of the cabi-
net, there must remain enough space to open the
appliance door.
1 Kitchen furniture
2 Dishwasher
3 Appliance door
Unit mm
Dimension and preparation of the decoration panel
Dimension and preparation of the decoration panel Dimension and preparation of the decoration panel
Dimension and preparation of the decoration panel
Prepare the wooden
decorative panel ac-
cording to the dimen-
sional drawing.
Unit mm
•
Align the drilling template and mark the necessary
holes. Check this with a spirit level.
•
Drill holes of Ø 2 mm and 8 mm depth at the pre-
marked positions in the panel.
Fixing the decoration panel
Fixing the decoration panel Fixing the decoration panel
Fixing the decoration panel
•
Insert the brackets into the holes of the decorative
panel and turn the screws in.
•
Hook the decorative panel with the brackets into
the provided slots on the appliance front.
•
Align the panel and the appliance front against
each other and fix the panel on the unit door.
•
First remove the factory-mounted short screws
(4xS1) from the door inside.
•
Screw the supplied long screws (4xS2).
Adjusting of the door spring tension Adjusting of the door spring tension Adjusting of the door spring tension Adjusting of the door spring tension
After fixing the decoration
panel, the door spring
tension must be adjusted
accordingly.