![background image](http://html.mh-extra.com/html/bomann/ek-6021-cb/ek-6021-cb_instruction-manual_2785747023.webp)
EK6021CB_IM
02.08.18
23
End of Operation
• Did you activate the timer, or do you only want to tempo-
rarily switch the appliance to standby?
- To do this, use the
ON / OFF
button on the remote
control or the
I
/
O
button (3) on the appliance.
• Do you want to disconnect the appliance from the
mains?
- Set the power switch (5) to position
O
. Disconnect the
power supply from the socket.
NOTE:
The appliance will not turn on after disconnecting it
from the mains, even if you have activated the timer.
The appliance will be reset to the basic settings.
Overheating Protection
The appliance is fitted with an overheating protection,
which will automatically turn off the appliance in case of
overheating. You will hear a warning signal. All segments in
the display start flashing. For safety reasons, the appliance
will not turn itself on again.
In order for the appliance to be operated again, proceed as
follows:
• Set the power switch to position
O
. Disconnect the
power supply from the socket. Let the appliance cool
down for approximately 15 minutes before you use it
again.
• Check whether the air intake or vent on the heater is
blocked. If necessary, clear the blockage.
In the event that the overheating protection turns off the ap-
pliance after a brief period, then there is probably a defect.
• Turn the appliance off again and unplug it from the
mains.
• Have the appliance checked by the dealer or by our
service.
Cleaning
WARNING:
• Before cleaning, always remove the mains plug and wait until
the appliance has cooled down.
• Make sure no water enters the openings of the appliance during
cleaning. Otherwise this might result in an electric shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• Clean the surface of the appliance with a soft dry cloth.
• The glass front may be wiped wet, if necessary. Then
dry it with a soft cloth.
Maintenance Instructions
• The appliance is equipped with an electronically con-
trolled LED system that projects the flame effect. This
system must
not
be serviced by the user.
• The LEDs of the lighting can
not
be replaced.
Troubleshooting
Problem
Possible Cause
Solution
The appliance does not work. The appliance is not connected to mains
power.
Check the wall outlet with a different appliance.
Insert the plug properly in the wall outlet.
Check the fuse.
The appliance is defective.
Contact our service or a repair centre.
The heater and the fan are
not working.
The room temperature is higher than the
base temperature for the heating.
Check the setting for the base temperature.