BOMANN DT 349, Instruction Manual

Page: 23 / 28

23
Cleaning the appliance including interior
Cleaning the appliance including interior Cleaning the appliance including interior
Cleaning the appliance including interior
•
Clean the appliance interior, the exterior surfaces,
the accessories and the door seal regularly with
warm water and mild detergent.
•
Remove for that the appliance content and stor-
age at a cool location.
•
Clean the thaw water discharge channel / opening
carefully e.g. with a pipe cleaner.
•
After everything was thoroughly dried, you can
restart the operation.
Defrosting
Defrosting Defrosting
Defrosting
CAUTION CAUTION CAUTION CAUTION::::
Never use metal objects (e.g. knifes) to remove ice
from the evaporator. Otherwise it can be damaged.
A defect evaporator can cause serious damage.
The
fridge
has an automatic defrosting system. Dur-
ing defrosting water drops drains off at the back of
the cooling chamber. The thaw water running
through a channel, is collected in a drip tray located
on the compressor, where it will evaporate.
Make sure the water discharge opening does not get
clogged. A light formation of ice on the interior back
during operation is normal.
To achieve better cooling and to save energy, defrost
the
freezer
regularly as follows:
•
To start the defrosting process turn the tempera-
ture control to the off state and disconnect the
appliance from the power supply.
•
Remove the food items and keep covered at a
cool location.
•
When the ice has melted, wipe the condensate
away and dry the appliance interior.
•
Then you may restart the appliance by connecting
the plug and turning the temperature control.
Reverse the bulb
Reverse the bulb Reverse the bulb
Reverse the bulb
Specification: 220
Specification: 220 Specification: 220
Specification: 220----240 V
240 V 240 V
240 V~~~~, max. 1
, max. 1 , max. 1
, max. 10000 W
W W
W
•
Loosen the screw of the lamp cover and remove
the cover to the back.
•
Replace the defective bulb.
•
Reattach the lamp cover and tighten the screw.
•
Reconnect the appliance and put into operation
again.
Troubleshooting Troubleshooting Troubleshooting Troubleshooting
Before you contact an authorized specialist
Before you contact an authorized specialist Before you contact an authorized specialist
Before you contact an authorized specialist
Problem Problem Problem Problem Cause / Action Cause / Action Cause / Action Cause / Action
Appliance is
not working
or not
properly
-
Insert the power plug correctly or check
the fuse.
-
Check the temperature setting.
-
Check the ambient temperature.
- Unblock the ventilation openings, install
the appliance freely.
Stored food
is too warm
-
Check the temperature setting.
-
Open the door only as long as neces-
sary.
-
Check the location.
Loud noise
during oper-
ation - Check the appliance position.
- See the section “Operating noise”.
Water on the
appliance
bottom - Check the temperature setting.
- Clean the water discharge channel /
opening.
Interior light
is not work-
ing
-
Insert the power plug correctly or check
the fuse.
- See the section “Reverse the bulb”.
NOTE: NOTE: NOTE: NOTE:
If a problem still persists after following the steps
above, contact your trader or an authorized techni-
cian.