BOMANN 779061, Instruction Manual

Page: 27 / 40

27
Installing the oven

Put the appliance with the connecting cable first
into the prepared cabinet a bit.

Do the connection to the mains, see
"Electrical
connection"
.

Insert the oven into the cabinet opening com-
pletely. Make sure that the cables do not re-
stricted (bent, squeezed or twisted).

Attach and secure the oven by using the supplied
screws on the side walls of the cabinet.
2x mounting holes
are located left and
right in the door
frame.
Electrical connection
Information for the authorized expert
WARNING:

The installation to the mains supply must conform
to the local standards and regulations.

Improper connection may cause to an electric
shock!

Do not change the appliance plug! Let replace the
mains plug by a specialist if this is not suitable for
the appliance plug.

Do not use multiple sockets or extension cords.

Before connecting, ensure that the power supply
corresponds with the information on the rating la-
bel (door frame) and the wiring diagram.

Connect the mains cable to a properly installed
and earthed wall outlet.

Arrange the mains cable in such a way that it
does not get in contact with any hot components
of the appliance. Do not lead it over sharp edges
or corners.

If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Connected load
In total, the appliance can take up a rated power of
approx. 2400 W. At this connected load, a separate
supply line for the oven with a 16-ampere fuse is re-
quired.
Startup / Operation
Before initial use

Clean the oven interior with all therein located ac-
cessories. Follow the instructions that we give you
in the chapter
"Cleaning and Maintenance".

To burn off possible production residues, heat the
closed oven for approx. 30 minutes at maximum
temperature (240°C_top/bottom heat).
NOTE:
The occurring odor and possibly a slight smoke
development cannot be avoided. So, ensure that
the room is well ventilated during the heating pro-
cess.
Operation overview
The detailed description of the individual controls can
be found in the following sections.
Control panel
1 Oven function selector control
2 Oven temperature selector control
3 Oven temperature control lamp
4 Digital timer with LED display
Function selector control
The function selector control is used to set the heat-
ing mode. To set a function, turn the control to the
symbol with the desired heating mode.