BOMANN 4004470760316, Instruction Manual

Page: 21 / 28

21
must be attached. Secure the hose with the enclosed
cable tie
(Fig. 2a) .

Hang up the housing. Check the secure hold and
the horizontal position. To secure the housing (D),
screw in the lower screws 2x ST4*30mm through
the housing
(Fig. 3) .

Fix the bracket (with angle) for the upper shaft
closure (A) with the screws 2x ST4*40mm after
determining the extension length of the shaft cov-
er
(Fig. 4)
.
For extraction mode:
Check the correct position of
the exhaust hose and connect it with the outlet open-
ing.

Fasten the outer (lower) shaft with the bracket
(without angle) using the 2x ST4*8mm self-
tapping screws
(Fig. 5)
.

Put on the telescoped shaft unit; fix the shaft unit
laterally to the housing with self-tapping screws
2x ST4*8mm and fix the middle shaft bracket (B)
with the screws 2x ST4*40mm
(Fig. 6) .

Pull up the inner shaft and fix the shaft cover lat-
erally to the shaft closure bracket using self-
tapping screws 2x ST4*8mm
(Fig. 7)
.
Installing the activated carbon filter for recirculation
mode

Remove the aluminum grease filter (see
“Clean-
ing the aluminum grease filter”
).

Place the carbon filter onto the
air intake of the extraction duct.
Make sure that the mounting
pins on the extraction duct engage the mounting
slots of the carbon filter. Turn the filter clockwise
until it clicks into place.

Reinstall the aluminum grease filter.
Electrical connection
WARNING:

The installation to the mains supply must conform
to the local standards and regulations.

Improper connection may cause to an electric
shock!

Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.

The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.

Ensure that your mains power corresponds with
the specifications of the appliance. The specifica-
tions are printed on the rating label.

Connect the mains cable to a properly installed
and earthed wall outlet.

If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Startup / Operation
The cooker hood is to operate via touch control:
Operation
Operation on / off
Power level
1 low → 2 medium → 3 high with Booster function
The display shows the selection.
Lighting
Lighting on / off
Ambient lighting (backlighting)
Function button for ambient lighting