Boltek LD-350, Installation & Operator’S Manual

Page: 8 / 27

3
Quick Start
1) Connect the USB cable from your computer USB port to the USB connector of
your LD-350.
2) Plug in the AC power adapter into the lead of the LD-350 and into an AC outlet.
Turn on the LD-350. The two yellow LEDs should blink three times, then the unit
will beep and illuminate the indicator lights for 2 seconds.
3) After the power is turned on, the USB drivers for the LD-350 should automatically
install if there is an active internet connection on the computer. If there is no
internet connection, the USB driver install program can be found on the Boltek
USB drive under: \LD350\USB_DRIVER\ .
4) Insert Boltek USB flash drive into available USB port on the desktop computer and
open File Explorer
5) Navigate to the LD-350 folder, then into the 32 or 64 bit installation folder
depending on your Windows Operating System.
6) Run the setup executable and follow the prompts to install the software. When you
get to the Choose Components screen, ensure that “StormTracker PCI device” is
deselected.
7) Run NexStorm software, along the top menu bar select Options, then
Configuration.
8) Select the Hardware tab, then select LD-350 under Receiver model
9) Under Receiver activation, check Enable on startup.