Boltek LD-350, Installation & Operator’S Manual

Page: 22 / 27

17
1.
Output Display
This window displays status messages, processed lightning strike information,
and LD-350 configuration settings. This is a display only and contents cannot
be modified here. Status messages will display automatically once per second,
strike and noise signals will appear as they are detected. Pressing the
Clear
button will clear this display window.
Note: Messages will not appear if the LTS-3 timestamp card is installed but can
be seen with ‘ STATUS’ command.
2.
Detection
Displays GPS Timestamp information when LTS-3 Timestamp is installed on
LD-350. This data will only display or update when USB Raw On button is
pressed and either a signal is detected or the Force Trigger button is pressed.
3.
Status
When the LD-350 is in Stand-Alone Mode (no LTS-3 Timestamp installed) it
will display Close and Severe storm alarm status, as well as the Close Strike and
Strike rate strike count. This mode will show LDN connections as
DISCONNECTED.
When the LD-350 is in LDN mode (with LTS-3 Timestamp installed) the alarm
status and strike counts are disabled and will only display the connection status
of the LDN Servers.
4.
Configuration
This section displays the configuration and alarm settings of the LD-350. Press
the Query button to view the current settings or any updated settings after
commands have been entered. The Save button should be pressed before the
LD-350 is powered off to save any configuration changes. The
Load
button
will revert the settings back to the last saved configuration.
5.
Command
This box is where the commands are typed. Pressing the Send button after
typing a command will update the corresponding setting on the LD-350. The
commands are case sensitive and should all be capitalized or the settings will
not update. See Appendix A for a full list of commands that can be used. The
Reset button restarts the LD-350, this is mainly used for confirming that any
changes to the settings have been saved properly. The Exit button will shut
down the Config Utility program.