STEP 11
STEP 11
USE THE TWO SMALL TIE STRAPS TO ATTACH
THE ANTENNA TUBE INSIDE THE CHASSIS NEXT TO THE
STEERING SERVO. RUN YOUR ANTENNA WIRE THRU THE
TUBE AND TAPE IT AT THE TOP. TAKE THE EXCESS
ANTENNA WIRE AND OTHER RADIO WIRES AND SECURE
THEM NEAR THE RECEIVER TO KEEP THINGS NEAT AND OFF
THE GROUND.
STEP 12
INSTALL YOUR BATTERY PACK UNDER THE
BATTERY TRAY WITH A LARGE TIE STRAP. ROUTE THE PLUG
THRU THE TRAY AT THE FRONT OR REAR SO YOU CAN
ATTACH IT TO THE ESC.
STEP 12
4
STEP 10
STEP 10
INSTALL YOUR ESC AND RECEIVER ON TOP OF
THE BATTERY TRAY WITH THE SERVO TAPE PROVIDED.
PLUG THE SPEED CONTROL AND SERVO INTO THE
RECEIVER. SOLDER THE MOTOR WIRES TO THE MOTOR AND
ESC OR ADD PLUGS AND PLUG THEM IN. MOUNT YOUR
RADIO SWITCH UNDER THE BATTERY TRAY BEHIND THE
STEERING SERVO. THIS WILL ALLOW YOU TO TURN THE CAR
ON OR OFF WITHOUT REMOVING THE BODY.
STEP 13
INSTALL ONE SMALL BUSHING FROM BAG 1L2
INTO EACH SIDE OF THE FRONT WHEELS. LUBE EACH STUB
AXLE WITH A DROP OF LIGHT OIL, THEN INSTALL THE FRONT
WHEELS AND RETAIN WITH A 5-40 LOCKNUT. LEAVE JUST
ENOUGH PLAY SO THAT THE WHEELS SPIN FREELY. THE
FRONT AND REAR BUSHINGS WILL LAST AND PERFORM
WELL IF YOU KEEP THEM CLEAN AND LUBRICATED.
STEP13
