24
Manual Focus variable speed, that has eight speed levels.
PRESET SPEED
Set the speed of the presets, value: 0-5
Near Limit
Can be set in a range from OVER, 1cm, 8cm, 30cm, 1m, 1.3m, 1.5m, 1.9m, 2.3m, 2.9m, 3.7m, 4.9m, 7m, 11m, 25m.
AF MODE: Auto Focus Mode
The Auto Focus (AF) function automatically adjusts the focus position to maximize the high frequency content of the
picture in a center measurement area, taking into consideration the high luminance and strong contrast components. The
minimum focus distance is 80 mm at the optical wide end and 1000 mm at the optical tele end.
- Normal AF Mode
This is the normal mode for AF operations.
- Interval AF Mode
The mode used for AF movements carried out at particular intervals. The time intervals for AF movements and for the
timing of the stops can be set in one-second increments using the Set Time Command. The initial setting for both is set to
5 seconds.
- Zoom Trigger Mode
When zoom position is changed, it becomes AF mode during the pre-set value (initial setting is set to 5 seconds). Then it
stops.
SYSTEM Menu
PELCO ID
When using RS485 (PELCO P/D) control, Set PELCO ID to the address that you want to control to. This value is from
000-255.
VISCA ID
When using RS422/ RS232 (VISCA) control, Set Camera VISCA ID to the address that you want to control to. This
value is from 0-7.
IR ADDRESS (Infrared Signal Reception)
Camera ID for IR Remote Controller. Value: 1-3
FACTORY RESET
You can select this item to set camera back to
Factory Default setting by pressing HOME button
to confirm the action. All data of the camera that
have been set will be deleted.
BAUDRATE:
This is the rate at which the camera expects
commands to be transferred from the keyboard
controller. This setting needs to match the baud rate
on the keyboard controller
RELOAD PRESET 1:
When this item is set to ON, preset 1 is set to Home
position. The camera goes to Home position when it
is powered on or reset.
PRESET MEMORY
Set the Preset Memory ON/OFF.
The presets can be set to memorize the video image parameters that are with the presets. This function allows you to
achieve the desired status instantly with the presets, even without adjusting the following items each time.
Pan/Tilt Position
Zoom Position
Focus Auto/Manual
Focus Position
AE Mode
Shutter control parameters
Bright Control
Iris control parameters
Gain control parameters
Exposure Compensation On/Off
Exposure Level
Backlight Compensation On/Off
White Balance Mode
R/B Gain
Aperture Control
>
EXPOSURE
>
WHITE BALANCE
>
PICTURE1
>
PICTURE2
>
ZOOM
>SYSTEM
OSD
PELCO ID
002
VISCA ID 1
IR ADDRESS 1
FACTORY RESET
BAUDRATE 2400
RELOAD PRESET 1 ON
PRESET MEMORY
ON
TALLY BRIGHT
LOW
VIDEO FMT 2160P29.97
SDI FMT 1080P29.97
SV: S0E0500S350801A01
SYSTEM
