32
SYSTEM Menu
PELCO ID
When using RS485 (PELCO P/D) control, Set PELCO ID to the address that you want to control to. This value is from
000-255.
VISCA ID
When using RS422/ RS232 (VISCA) control, Set Camera VISCA ID to the address that you want to control to. This
value is from 0-7.
IR ADDRESS (Infrared Signal Reception)
Camera ID for IR Remote Controller. Value: 1-3
FACTORY RESET
You can select this item to set camera back to
Factory Default setting by pressing HOME button
to confirm the action. All data of the camera that
have been set will be deleted.
BAUDRATE:
This is the rate at which the camera expects
commands to be transferred from the keyboard
controller. This setting needs to match the baud rate
on the keyboard controller
RELOAD PRESET 1:
When this item is set to ON, preset 1 is set to Home
position. The camera goes to Home position when it
is powered on or reset.
PRESET MEMORY
Set the Preset Memory ON/OFF.
The presets can be set to memorize the video image parameters that are with the presets. This function allows you to
achieve the desired status instantly with the presets, even without adjusting the following items each time.
•
Pan/Tilt Position
•
Zoom Position
•
Focus Auto/Manual
•
Focus Position
•
AE Mode
•
Shutter control parameters
•
Bright Control
•
Iris control parameters
•
Gain control parameters
•
Exposure Compensation On/Off
•
Exposure Level
•
Backlight Compensation On/Off
•
White Balance Mode
•
R/B Gain
•
Aperture Control
•
WD Parameter
VIDEO FMT:
You can change the video format by adjusting this item. Select the item, press “←” button to choose the video format you
want to set to, then press “→” (Pressing “→” button changes value on some product models) or HOME button to confirm
it. After you confirm your choice, press HOME button again to restore it. The camera will reboot by itself. The new video
format is activated.
You can cancel it by pressing the MENU button.
The video formats that you can select from are: 2160p:29.97/25; 1080p:59.94/50; 1080i:59.94/50; 720p:59.94/50
You can select SDI video format are: 1080p:59.94/50/29.97/25/23.98; 720p:59.94/50.
SDI 1080p23.98 can be gained when
Video FMT
is set to 2160p:29.97/25.
SV (Software Version):
This item refers to the MCU firmware version that is currently running on the device.
>
EXPOSURE
>
WHITE BALANCE
>
PICTURE1
>
PICTURE2
GAMMA
>
ZOOM
>SYSTEM
OSD
PELCO ID
002
VISCA ID 1
IR ADDRESS 1
FACTORY RESET
BAUDRATE 2400
RELOAD PRESET 1 ON
PRESET MEMORY
ON
HDMI OUT RGB
VIDEO FMT 2160P29.97
SDI FMT 1080P29.97
SV: S0E0500S35080AA07
SYSTEM
