9
2.2.6
Extreme Situation Actions
3
Maintenance
3.1
General
The product is to be maintained according to a planned preventive strategy which provides
annual scheduled maintenance.
3.2
Safety Precautions
The detector should be maintained by personnel qualified for the Accident Prevention Level of
II or higher.
3.3
Maintenance Procedures
Scheduled maintenance works include:
–
Visual checking of the interface converter conditions;
–
Checking conditions of external installation wires and contact joints;
–
Checking operability as per Clause 3.4 of this manual.
3.4
Performance Testing
3.4.1
Testing operation capability of the interface converter as part of an S2000M panel is testing the
panel for stable communications with a personal computer using PProg utility. Put the panel to the
programming mode, and then conduct reading / writing the S2000M configuration.
3.4.2
Indicator’s illuminating means receiving / transmitting signals over the RS-232 interface line.
3.5
Technical Examination
Technical examination is not applicable for this equipment.
3.6
Preservation (Depreservation, Represervation)
Preservation is not applicable for this equipment.
4
Repair
4.1
Repair of faulty equipment is to be conducted by the manufacturer or in authorized repair centers.
The equipment shall be sent for repair in line with established procedures.
4.2
An equipment fault resulted from consumer’s not observing rules of mounting and operation is not
a reason for claims and warranty repair.
4.3
Claims shall be submitted to the following address:
NVP BOLID, #4 Pionerskaya Str., Korolyov, Moscow Region, 141070, Russia
Tel./fax: +7 (495) 775-71-55 (PBX), Email:
.
4.4
In case of any issue related to use of the product, please contact the technical support: +7 (495)
775-71-55 or e-mail:
.
Warning!
If sparks, fire, smoke, and / or smell of burning are found at the installation site of the
device, the device must be de-energized and sent for repair
WARNING!
Removing the device’s PC board from its housing automatically voids the
manufacturer’s warranty
Attention!
The equipment shall be submitted for repair being assembled and clean and along
with all the parts listed in the documentation.
Claims are accepted only if a reclamation report describing the failure is applied to
the submitted equipment.
