6
5
MODULE OPERATION
5.1
Indication Modes
5.1.1
Table 2 shows the indication modes for the power LED
(the upper indicator at the right
of the device name) depending on the module’s conditions.
Table 2.
Power LED
Indication Modes
Module Conditions
Performance
1. Norm
Lit steady with green
2. Power Failed
Pulses in green once per second
3. Programming (Upgrading firmware)
Pulses in green four times per second
5.1.2
Tables 3
–
11 show performance of LEDs “1” – “60” depending on the status of partitions
and selected indication types. If a partition features several states then a status of more priority is
indicated. Tables 3 – 15 show partition states in the descending order of priority. If none of partition
conditions complies with states listed in the table then the relevant indicator is turned off.
The indication type “Security Alarm” is meant for indicating conditions of security and safety
partitions.
Table 3.
Performance of LEDs “1” – “60” for Indication Type
“Security Alarm”
Partition Status
Indicator “1” – “60” Performance
Panic Alarm (Panic Alarm, Duress),
Flooding Alarm, Intrusion Alarm
Pulses with red: 0.5 s On / 0.5 s Off
Trouble
(All troubles including alarm loop troubles, troubles of
outputs, power failures, communication loss, etc.:
Fault, Input Open Failure, Input Short Failure,
Configuration Error, Tamper Alarm,
Output Open Failure, Output Short Failure,
Mains Failed, Overload, Battery Test Error, Power
Failed, Charger Failed, Battery Failed, Low Battery,
Low Backup Battery, Level Above Limit, Level
Below Limit, Noise, Actuator Failure, Actuator Error,
Service Required, Temperature Sensor Fault,
Input/Output/Unit Communication Fault,
Error Authenticating Device, PL Short Circuit Fault,
PL Overvoltage, PL Communication Error,
PL Communication Unstable, PL1 Communication
Lost, PL2 Communication Loss, Communication
Link Failure, Activation Failed)
Pulses with amber: 0.25 s On / 1.75 s Off
Arming Failed
Pulses with amber: 0.5 s On / 0.5 s Off
Entrance Alarm
Pulses with red: 0.25 s On / 0.75 s Off
Disarmed
Lit steady in green
Arming in progress…
Pulses in green four times per second
Armed
Lit steady in red
Disabled
Lit steady in amber
(with S2000M of version 3.00+)
The indication type “Security 2 Alarm” differs from the “Security Alarm” type only by LED’s
being turned off for the Disarmed status.
Table 4.
Performance of LEDs “1” – “60” for Indication Type
“Security 2 Alarm”
Partition Status
Indicator “1” – “60” Performance
Panic Alarm, Flooding Alarm,
Intrusion Alarm
Pulses with red: 0.5 s On / 0.5 s Off
Trouble
Pulses with amber: 0.25 s On / 1.75 s Off
