Boldan Oy, Matkuntie 3, FIN-05200 Rajamäki | www.boldan.
fi
| +358 (0)9 853 1042
Miniroller D200 e
Manual
7
4 MAINTENANCE
When maintaining the Miniroller one must follow the installation, operation and maintenance instructions
in this manual and above all pay attention to the warnings section. Maintenance can only be performed
by person familiar with the instructions. The person maintaining the Miniroller must have comparable
knowlegde to the person operating the Miniroller.
Miniroller must be cleaned of trash and dirt.
Electricity must be disconnected while maintaining or repairing Miniroller. The main switch must be
turned to position 0 and electricity must be unplugged from power network.
Maintaining rollers
• Dirty roller must be cleaned before use.
• Broken bearings must be replaced.
• Tilted rollers must be straightened.
• Damaged surfacing of pulling roller must be removed and replaced.
Cleaning of rotating roller
The easiest way to remove grime, such as grease, is to wipe the surface with a damp cloth and cleanser
(check suitability for rotating roller). Thin, quickly evaporating
fi
lm of cleanser does not damage the rota-
ting roller. It is recommended to use Scrubs -cleaning cloth or such.
4.1 ELECTRIFICATION
Person in possession of Miniroller must make sure that the machine functions without disturbances when
operating and maintaining the it. Protection of electric shocks and
fi
re must also be taken care of.
Person in possession of Miniroller is responsible for carrying out these obligations by monitoring the ma-
chine by regular or continuous inspections and, when needed, by measurements and testings. Person in
possession of Miniroller must take care that failures and malfunctions are repaired immediately.
