IMPORTANT! INSTALLER PLEASE NOTE
Wall mounting structure must be capable of supporting 300 lb. load on fountain.
This fountain is to be mounted on a
smooth, flat, finished wall surface with
adequate support structure.
Wall should already be framed for the
fountain using dimensions shown in
rough-in’s below. Shown dimensions
pertain to installation location.
Remove bottom cover from fountain
and save the screws. Assemble the push
rod to the fountain. (Push rod provided
with freeze resistant box)
Install the fountain using bolts and
washers (not provided). Tighten securely.
Attach drain tube to fountain and cut
to required length using the freeze
resistant box as a guide.
Install freeze resistant box - see box
instructions.
Install a service stop (not provided) and
make water supply connection from
the stop to the strainer in the freeze
resistant box.
DO NOT SOLDER TUBES INSERTED
INTO THE STRAINER AS DAMAGE TO
THE O-RINGS MAY RESULT.
Connect fountain water line to freeze
resistant box - see box instructions.
Replace the bottom cover.
1
2
3
4
5
6
7
8
GENERAL INSTALL TIPS
7/16”
11 mm
MOUNTING
HOLE (3)
12 7/8”
327 mm
3”
76 mm
1 3/4”
44 mm
WASTE LINE
3”
76 mm
3 7/8”
98 mm
2”
51 mm
7/16”
12 mm
5 3/16”
132 mm
29 1/8”
740 mm
29 7/16”
748 mm
1”
25 mm
FOR PUSHROD
7/8”
22 mm
O.D.
WATER
INLET
(3)
FINISHED FLOOR
27”
686 mm
13 7/16”
342 mm
15 1/4”
387 mm
19 ”
482 mm
FREEZE
RESISTANT
BOX
35 1/2”
902 mm
WASHER
ACORN NUT
CLOSET SCREW
OR THREADED ROD
(DEPENDING ON WALL TYPE
AND ANCHOR USED)
FIGURE 1
SUGGESTED CONFIGURATION
FOR EXPOSED MOUNTING BOLTS
NOTE
DFWM-12-FR height is the same as
DFWM-19-FR
FIGURE 2
34”
864 mm
7 1/4”
184 mm
12 7/8”
327 mm
DFWM-12-FR
2
DFWM-12-FR & DFWM-19-FR — Owner’s Manual
3
Bohlmann Quality Products — www.bohlmann.com
DFWM-19-FR
