Bohell TPLI18, Manual

Page: 19 / 36

SPEED CHANGE
-The appliance has two sets of gears in order
to change the movement transmission so the
velocity can be modified using the gear selector
(D).
ELECTRONIC SPEED CONTROL:
-The speed of the appliance can be regulated by
using the speed regulator control by pressing
the on / off switch. This function is very useful,
as it makes it possible to adapt the speed of the
appliance to the type of work that needs to be
done.
ROTATION DIRECTION CHANGE:
-The appliance has a selector, which allows the
direction of rotation to be changed. (E)
-When the selector is placed in the middle posi-
tion the tool will be locked.
FUNCTION SELECTION
DRIVING FUNCTION:
-Turn the selector (C) until the arrow on the
power tool, above the selection rings, points the
screw image.
-Then select the Torque function. Remember the
torque force settings are only available in driving
function.
DRILLING FUNCTION
-Turn the function selection ring (C) until the
arrow on the appliance points to ( )
DRILLING WITH IMPACT FUNCITON
-Turn the selector (C) until points to ( )
USE:
-Turn the appliance on, by using the on/off
switch.
-WARNING: When the bit begins to penetrate
concrete or comes up against the reinforce-
ment rods in the concrete, the tool may react
dangerously. Make sure you keep your balance
by distributing your weight evenly and keeping
your feet in a safe position whilst holding the
tool firmly in both hands to avoid dangerous
reactions.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
-Stop the appliance by releasing the on/off
switch.
-Clean the appliance.
CLEANING
-Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
-Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
-Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
-Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
-Never submerge the appliance in water or any
other liquid or place it under running water.
-If the appliance is not in good condition of clean-
liness, its surface may degrade and inexorably
affect the duration of the appliance’s useful life
and could become unsafe to use.
SUPPLIES
-Supplies can be acquired from distributors and
authorised establishments (such as filters, etc. )
for your appliance model.
-These supplies are available in specialist shops.
ANOMALIES AND REPAIR
-Take the appliance to an authorised technical
support service if product is damaged or other
problems arise. Do not attempt to disassemble
or repair the appliance yourself as this may be
dangerous.
-If the connection to the mains has been dam-
aged, it must be replaced, take the appliance to
an authorised technical support service. Do not
attempt to disassemble or repair the appliance
by yourself in order to avoid a hazard.
SPECIFICATIONS TPLI18
Rated Voltage 20V
Battery Capacity 1,5 A·h
No load speed 0-400 / 0-1400 rpm
Max drilling torque 35 Nm
Max capacity in steel 10 mm
Max capacity in wood 25 mm
Max cap. in masonry 6 mm
Drill chuck capacity 10 mm
Keyless chuck Yes
No. of torque settings 18+2