S-line
5
o
The spreading vanes are set by loosening the vane bolts and then place and fix the
vane in the requested position.
In case the material is supposed to be distributed even more to the left side of
the spreader, the vane's inner fixture can be moved to track B.
PTO-RPMs
The spread chart states the PTO speed:
The PTO revolutions per minute are decisive for the spread width and are also
of importance for the distribution of the material.
If the PTO revolutions per minute are lower than the stated number of
revolutions
– the spread width will be reduced and the sidewise distribution will
at the same time be increased to the right of the machine.
The operation of the agitator is directly depending on the number of revolutions
of the PTO. At a low revolution figure the operation of the agitator will be
reduced
– at a too high revolution figure the agitator will be under too high
pressure, which involves increased wear and possible defect.
The stated PTO speed MUST be respected.
LIMITER
The spread chart states the respective settings of the limiter:
Minimum
:
Minimum spread width approx.
1 metre
– skirt mounted.
Middle
:
Middle position marked at lock for
adjustment of the limiter.
Maximum
:
Max spread width with
limiter in upper position.
Limiter demounted
: ÷
limiter is demounted when spreading
for instance mineral fertiliser.
The setting / position of the limiter is decisive for the spread width and can be
steeples adjusted until the required spread width is reached.
Pos 1
Track A,
Standard
Pos 4
Track B
Special