
S-line
11
LUBRICATION
The components below must be greased according to below
instruction
.
See the explaining sketch in the paragraph
”OVERVIEW”
.
LUBRICATION ONCE A DAY:
COMPONENT
INSTRUCTION
Cardan joint and lock of the PTO
Telescope axles of the PTO
Setting and closing shutter
(Bottom of hopper)
Use grease
Use grease
Use grease
PARTS GREASED ONCE:
The angle gear is filled with special grease and needs no lubrication.
GENERALLY
A new machine will always ”move” a little bit in all nuts + bolts.
Therefore, all
the machine’s nuts and bolts must be retightened -
first time it is put into operation
– after 3 to 5 hours operation.
Exception is the
angle gear’s bolts – these are locked and sealed
with Locktite.
Special attention is needed towards the spreader’s 6 M12 bolts
tightening the hopper
– these are tightened with a 90 Nm torque.
Be aware that stainles
s nuts + bolts might ”weld together”. When
mounting such bolts
– the thread must be greased with cutting
lubricant or copper grease!
SPREADING VANES
The vanes will be worn due to the material. Therefore, the vanes are
to be considered a wearing part
– that must be exchanged
dependent on the quantity and type of material.
Always clean the contact surfaces of the vanes and the
spreading disc for dust etc
– before mounting and tightening
the vane!
IF HOLES ARE WORN IN THE VANES THEY MUST BE EXCHANGED AT ONCE!