10
7.
MAINTENANCE
1.
When running belt is off the center, stop the
treadmill immediately, use Allen Wrench to
adjust the hex head screw. For example, the
running belt is offset to the left it should adjust
1/4 circle clockwise; if the running belt is offset
to the right, adjust 1/4 circle counterclockwise.
After adjustment, start the treadmill again, if the
running belt still off the center, repeat the
adjusting procedure till the running belt is in the
center position.
(Ps.1. This action is very important, if a deviated
belt is found, be sure to follow above
procedure.)
(Ps.2. Belt may move away from center status
due to user’s weight and running condition. The
belt needs not to be adjusted as long as it doesn’t
rub against the parts aside.)
2.
It is strongly suggested to follow the below table
to apply lubrication on running board. Please use
Allen Wrench to loosen bolts in rear adjusting
boxes. Pull up the running belt and apply
lubrication evenly on the center of the running
board, then adjust the belt to the center of deck,
follow by tighten the screw to the original set up.
(Ps. When the belt is sliding, please follow
the above method to apply lubricant on the
running board. )
Speed
Interval
1~6 km
1 year
6~16 km
6 months
