BODYMAX CVEB2704, Assembly And Operating Instructions Manual

Page: 8 / 32

8
FXB10 Folding Bike
+ Only authorized service technicians are permitted to carry out all servicing and/or repairs –
it excludes maintenance and care.
+ Damaged or worn components may impair your safety and the lifespan of the equipment.
You should therefore immediately replace damaged or worn components. Please contact
your contract partner in such a case. The equipment should no longer be used until it has
been repaired. When needed, only use original BodyMax spare parts.
+ Check the tightness of all screw connections once a month.
+ In order to be able to guarantee the constructively defined safety level of this equipment,
we recommend having the equipment regularly maintained (at least once a year) by
specialists (service technicians of your contract partner).
+ The equipment may be cleaned of dust, dirt and sweat using a damp cloth. The use of
solvents should be strictly avoided. Also, make sure that no liquids (e. g. sweat) get into the
openings of the equipment (e. g. console).
3.2 Faults and Troubleshooting
The equipment runs through regular quality controls during production. Nevertheless, errors
or malfunctions on the equipment may occur. Individual parts are often the cause of faults
and replacement is usually sufficient. Please use the following overview to see the six most
common errors and how to repair them. If the equipment still does not work properly, please
contact your contract partner.
Problem Solution Solution Solution
There is no
display on
the computer
console.
Remove the computer console
and verify the wires that comes
from the computer console are
properly connected to the wires
that come from the frame.
Check if the batteries
are correctly
positioned and the
battery springs are in
proper contact with
the batteries.
The batteries in the
computer console may
be dead. Replace the
dead batteries with
new batteries.
3.3 Maintenance, service calendar and storage
The equipment needs to be cleaned after every training session with a moist towel (no
solvent!) in order to avoid damage caused by sweat.
The following routine work must be done in the specified time intervals:
Part Weekly Monthly Annually
Check screws I
Cleaning
The bike can be cleaned with a soft clean damp cloth. Do not use abrasives or solvents on the
plastic parts. Wipe your perspiration off the bike after each use. Be careful not to get excessive
moisture on the computer display panel as this might pause an electrical hazard or electronics
to fail. Keep the bike , especially the computer console out of direct sunlight to prevent screen
damage. Inspect all of the assembly bolts, nuts, screws, and pedals on the machine for proper
tightness every week.
Storage
Store the bike in a clean and dry environment away from children and pets.