BodyCraft SW-95.0201, Assembly And Operating Instructions Manual

Page: 40 / 60

40
Galena
Step 2: Assembly of the Leg Press Cable
L
NOTICE
If the pulleys (49) were previously assembled, they might need to be removed first and re-
assembled during cable routing.
1. If previously installed, completely remove the ab cable (94a) by unscrewing the bolt (80)
[fig. uA7].
2. Insert the ball end of the leg press cable (223) into the slot in front of the press upright (3) and
pass the cable (223) over the pulleys A1 and A2.
3. Pass the cable (223) down and under pulley A3 and up over pulley A4.
4. Pass the cable (223) down and under pulley A5 and over A6.
L
NOTICE
For the positions A7, A8, A9, A10 and A11, the pulleys (220) are assembled as shown
simultaneously during cable routing.
5. Pass the cable (223) under pulley A7 and A8, over A9, under A10 and over A11.
6. Insert the eyelet end of the cable (223) into the bracket of the leg press support (204) and secure
with one bolt (235), one washer (239) and one nylon nut (241) [fig. A12].