BodyCraft SW-95.0201, Assembly And Operating Instructions Manual

Page: 28 / 60

28
Galena
Step 7: Assembly of the Pec Dec Cable
࣑
ATTENTION
The pulleys must be assembled simultaneously while passing the cable.
1. Loosely attach the pulleys P2 and P4 and the pulley guide brackets (18) to the pec dec pulley
bracket (12) with one bolt (82) and one nut (87) each.
2. Insert one end of the pec dec cable (46a) into the right adj. cam (14).
3. Route the cable (46a) as shown over the pulley, behind the pec dec upright (2), over the pulley
and insert the other cable end into the left adj. cam (14).
4. Place pulley P3 over the pec dec cable (46a).
5. Attach the adj. pulley block (29a) to the pulley P3 with one bolt (82) and one nut (87) and let the
pulley block (29a) dangle behind the pec dec upright (2).
6. Tighten the bolts.
࣑
ATTENTION
Make sure the pulley guide bracket (18) does not rub on the cable throughout the entire range
of motion.