BodyCraft Multi Gym GX, Assembly And Operating Instructions Manual

Page: 15 / 48

15
2.3 Assembly
Before assembly, take a close look at the individual assembly steps shown and carry out the assembly
in the order given.
L
NOTICE
First loosely screw all parts together and check that they fit properly. Tighten the screws using
the tool only when you are instructed to do so.
Step 1: Assembly of Front and Rear Upright, Guide Rods and Weight Plates
1. Assemble the front upright (3) to the base frame (1) by using two bolts (99), four washers (116) and
two nuts (116).
2. Assemble the shorter pop pin (86) to the front upright (3).
3. Assemble the rear upright (4) to the base frame (1) by using three
screws (109) and three washers (116).
4. Insert two guide rod holders (73) into the holes on the
base frame (1).
5. Insert two guide rods (5) into the guide rod
holders (73).
࣑
ATTENTION
+ If you have purchased the optional 200Lbs
pound weight stack, please use the 200Lbs
shorter stack spacers (23A) instead of the
150Lbs longer stack spacers (23).
6. Slide two 200Lbs stack spacers (23A) onto the
guide rods, followed by two rubber cushions
(79).
7. Slide the weight plates (40) onto
the guide rods (5), making sure the selector
holes point towards front and rear side.
8. Attach the top plate (39) to the selector rod
(38) by using the top plate bolt (105). Tighten
the top plate bolt (105) by using a hex key.
9. Slide the top plate (39) onto the guide rods and
guide the selector rod (94) through the center holes
of the weight plates (40).
10. Insert two end plugs (70) into the ends of the round foot
plate tube.
11. Insert one end cap (66) into the rear of the base frame
(1).
12. Insert one end cap (67) into the side of the base frame
(1).