BodyCraft BC-F438, Assembly Instructions Manual

Page: 16 / 36

16
F438
Step 4: Assembly of the weight blocks
࣑
ATTENTION
If your weight block consists of 19 weight plates, do not install the Stack Spacers (220) (fig. 1&2).
1. If your weight block has 14 Weight Plates (222) each, slide the Stack Spacers (220) over each
Guide Rod (204) (fig. 2).
2. Slide one Rubber Cushion over each Guide Rod (204) and insert the Guide Rod Holders (288) to
the respective slots of the Connector Rear Stabilizer (201).
3. Insert the Guide Rods (204) into the Guide Rod Holders (248).
4. Slightly tilt the Guide Rods (204) and slide the Weight Plates (222) over the Guide Rods (204).
࣑ ATTENTION
Make sure that the selector holes on the weight plates are facing down and point forward.
5. Mount the Top Plate (221) to the Selector Rod (223) using the Top Plate Bolt (258) and tighten
the bolt.
6. Insert the Selector Rod (223) through the opening of the weight blocks.
7. Mount the Top Plate Guide Rod Holder (210) to the Guide Rods (205) using the four 5/16” X 1/4”
Inner Hex Screws (263).
8. Mount the Top Plate Guide Rod Holders (210) along with the Guide Rods (205) to the Connector
Rear Top Frame (202) along with the Stopper (246) using a total of four 5/16” X 5/8” Hex Socken
Dome Bolts (260) and two 3/8” X 5/8” Hex Socken Dome Bolts (259).
9. Insert the Selector Pin (241) in one of the selector holes of the Weight Plates (222).
10. Tighten the bolts.